Forum > General Corrado chat > frustration 2 tha max

This topic counts 1 page 1
Bozo Bozo from Netherlands (Groningen) posted @ 30 November 2006 20:32:29
Database Professional


283 Topic posts
Private message

1990 Corrado 1.8 G60

i am very frustrated ...
my car whent throug apk checkup and failed the test of co emision it was 0.6% ,
reason was i didnt have a cat under the car and i should buy one for 300E ,
i didnt beleave the garage so i went to an other garage and the corrie had there 0.5% it even went lower as the car got warmer it eaven hit 0.4% very nice but i wasnt convinced so i went to another garage and it had the same result 0.4% co2 and thats very good for a c.
thats 2 garages against 1 and the original first garage will not giv me a refund or retry for the check up they faild to do.
so i am very frustrated and disapointed at the garage.

2damn dangerous 2damn dangerous from Netherlands (Friesland) posted @ 6 December 2006 08:09:16
Database Amateur


63 Topic posts
Private message

1992 Corrado 2.9 VR6 Turbo

bommer dude

Bozo Bozo from Netherlands (Groningen) posted @ 6 December 2006 21:20:15
Database Professional


283 Topic posts
Private message

1990 Corrado 1.8 G60

well santa was a great sport this time 05 december she went trought the apk with no problems
co2 waz 0.4%

MacFly MacFly from Netherlands (Noord-Brabant) posted @ 7 December 2006 00:07:12
Database Semi-Pro


148 Topic posts
Private message

1993 Corrado 2.9 VR6

What to do if you fail an emission test just by inches? A relative of mine once got the advice - before checking the co2 emission - to drive for a couple of miles with the car so the engine gets warmer. Then go to the test station. The emission of co2 than will be at the lowest rate possible. Greetz Johan

Bozo Bozo from Netherlands (Groningen) posted @ 8 December 2006 19:28:30
Database Professional


283 Topic posts
Private message

1990 Corrado 1.8 G60

well the engine must be hot atleast 90 degrees prefrably 100c .
u could take of the vacuum hoze from the ic in the back of your throttle body.
u could take of an injector but she will run on 3 cilinders.
take of tha lamba could do it but i doubt that.
set the potentio meter in the intake 2 999 ohm or 635 ohm orignal factory default is 905 ohm.
if all this wont do tha trick go 2 dokter dik and get ur self a better chip in the motormanagement

all the above wasnot necasery for my raddo as i am pleased to know

This topic counts 1 page 1